Parts for M1 Carbine, USGI and Universal parts

Prices are plus shipping unless otherwise stated. Will combine shipping 
 

USGI parts:

stripper clips with loader: $10 each 20 some available 

30 round mag pouch: $40

Korea era belt mag pouch: $35

recoil check: $120

Bravarian style rear sight: $25

extractor: $25

firing pin: $30

ejector and spring: $8

Type 3 sear: $35

type 3 hammer: SGmarked: $40

M2 Carbine style mag catch with dog leg for the 30 round magazines: $50

Magazine floor plates: $4 a piece 3 available

magazine follower with bolt stop: $8

Magazine spring, for 15 round mag. $14

magazine spring for short, pro mag style 5 round mag: $7

Safety, lever style: $20

Gas piston and screw,used: $30

trigger spring: $9  2 available 

The trigger housing is an original USGI Type 4 “brazed” Underwood (•U• marked) production, and all internal parts are also Underwood. Housing itself has some pitting along the bottom (pictured) but functions just fine. I disassembled it, cleaned it, and re-assembled. Would be a great candidate for refinishing, or for a carbine with that “worn and torn” look. $130

UNIVERSAL PARTS:

5/30 Mags marked M2, one side is good on each mag, the other is rough. $35 each 

USGI Type 6 slide with modified case deflector lug, made by Springfield Armoury. $80

Firing Pin with spring: $30

Stripped trigger group, includes hammer pin, trigger pin, and roll pin to hold assembly to receiver: $20

Recoil spring guide: $5

Hammer: $35

Hammer spring plunger and spring: $10