Beretta 1301 prolifter at home **Instock**

Back in stock

3d printed part made with high density and high temperature nylon that turns your gen 2 or gen 1 shell lifter into the pro lifter that stays in the down position when the bolt is closed.  It also doesn't exist because it is always out of stock.

Instructions:

You must drill a pilot 1/8 inch hole into your lifter and the template hole is built into the part.  The part has a alignment nub that fits exactly to your lifter.  I recommend epoxy or supergluing the part in place so you can drill through in the right place.  You can then secure it with your fastener of choice plus some epoxy.  Works well and works as intended.  Reversible mod except there will be a hole.

Free shipping snail mail.  Will ship tracked if requested for additional cost.  E transfer only.  Until supplies last.