Snider Enfield P1853 & Martini parts, carbine rear sight, receiver, Breech Block, Springfield 1873 bands, etc.

Original Martini-Henry Rifle Breech Block Axis Split Pin $28

Snider receiver complete with breech plug $100. Breech block $45. 

The breech block axis pin with hole upon which the breech block actuates to extract is $40

The P1853 sight base only (screw mount hole in front) $35. Carbine rear sight in exceptional condition is $140. The rear sight with hole at front is actually Remington Rolling block, it is $80

P1853 trigger guards $60 for the nice one, $10 broken one (can be restored). The steel trigger guard nub is free to anyone who wants it. The fancy beaver tail example I haven’t identified but I think is a commercial Enfield, please anyone write, $175 for now. 

Wood stock ferrules, brass bolt head supports, $15 each. There are two brass, one with square wings and one with round. Only  one steel. Buttplate screws are $9 each. Ask about any parts I forgot to price. Other screws $12 each. 

Brass wood stock end cap, $30.

The steel tubes which support screws are $10 each. 

Enfield Scear (sear) $45

Trigger $30

P1853 steel buttplate $40 buttplate screws, $9 each

Martini buttplate $60, smooth type, original (not reproduction).

P1853 hammers, three different types. Flat faced hammer is for a Mark III Snider the other two are for Mk. 1 to Mk. 2 ** are short (pivot point to hammer face), two are recessed one is flat, other differences also. I assume but haven't confirmed the short ones are carbine, each are $40

P1853 barrel bands are $35 for the large one, $25 the mid size.

Brass mirror inspection tool, possibly intended for Vickers, $80

Btw I have Springfield bands with the “U”  $40 not in photos.

The prices will go down until sold. 

Send email for higher resolution photos.

Postage is $20.88 in prepaid box for parts thicker than 20 mm. Small parts that fit in paper envelope are $2 to ship. Large TYVEK envelope $7. 

I avoid bargaining and instead lower prices until sold.